Diaphragm pumps without compressed air. Up to 80% less energy.
A QUANTM works like the diaphragm pump you know, but runs on electricity instead of compressed air. No compressor running all day, so a far lower energy bill.
- Models
- 7
- Capacity
- 115 – 870 l/min
- Power supply
- 230 V or 400 V
- Savings
- up to 80%
New Graco QUANTM i230
The largest QUANTM yet. 870 l/min, without compressed air.
For the heavy work that until now only a large air-operated pump could do: 3″ flanges, 6.9 bar and solids up to 9.5 mm. On 400 V, with the controls in the pump and a motor sealed off from the fluid.
- Capacity
- 870 l/min
- Pressure
- 6.9 bar
- Connection
- 3″ ANSI
- Power supply
- 400 V, 3-phase
7 models in 4 sizes. Choose by capacity.
Each size comes in an industrial (i) and a sanitary (h) version; the new i230 is industrial only.
-
115 l/min
7 bar · 1″ · 230 V
-
300 l/min
7 bar · 1½″ · 230 V
-
450 l/min
5 bar · 2″ · 230 V
-
New 870 l/min
6.9 bar · 3″ · 400 V
Savings check What does switching save you?
Which QUANTM?
Everything a diaphragm pump does. Except the compressed air.
-
No compressor needed
Straight from the mains. No air line, no frozen air motor, no leakage losses.
-
Stops by itself under pressure
Just like an air pump: close the valve and the pump holds pressure without damage. Running dry is fine too.
-
Control built into the pump
Set the flow with one knob, or remotely through the controls. No separate frequency drive.
-
Steady flow
No more fluctuations because the factory's demand for compressed air goes up and down.
If electricity is expensive and compressors run all day to keep your air-operated diaphragm pumps going, now is the time to switch to electric diaphragm pumps from Holland Air Pumps.
We are amazed by the enormous energy savings that can be achieved by using the latest electric diaphragm pumps from Holland Air Pumps.